| Parameter | Standard | Reading | Result |
|---|---|---|---|
| Contact Detection — Pressure | 70 ± 4 kPa | pending | |
| Internal Head Sensor — Flow Rate | ≥ 3.5 L/min | pending |
Entry runs column by column: Enter steps from A through T within one column, then jumps to the top of the next. Vacuum Pressure accepts values with or without a minus sign (−88 and 88 are treated alike); the decimal separator may be a point or a comma. Internal Head Sensor Pressure: shaft A is the reference shaft, calibrated to 65 kPa (tolerance ± 2.5 kPa). All other shafts are acceptable up to ± 10 kPa; beyond ± 5 kPa deviation the value is flagged as borderline in yellow.
| Shaft | Internal Head Sensor | Vacuum — Z1 | Vacuum — Z2 | Vacuum Break Down | Nozzle Cleaning | Valve Air Stick | Overall | ||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| Pressure (kPa) A: 65 ± 2.5 · B–T: 65 ± 10 |
Pressure (kPa) |Wert| ≥ 80 |
Flow (L/min) ≥ 2.0 |
Pressure (kPa) |Wert| ≥ 80 |
Flow (L/min) ≥ 2.0 |
Pressure (kPa) 10 – 15 |
Flow (L/min) ≥ 0.5 |
Pressure (kPa) ≥ 100 |
Flow (L/min) ≥ 0.8 |
Repeated Sliding (mm) |Wert| ≤ 0.08 |
||
| A | — | ||||||||||
| B | — | ||||||||||
| C | — | ||||||||||
| D | — | ||||||||||
| E | — | ||||||||||
| F | — | ||||||||||
| G | — | ||||||||||
| H | — | ||||||||||
| I | — | ||||||||||
| J | — | ||||||||||
| K | — | ||||||||||
| L | — | ||||||||||
| M | — | ||||||||||
| N | — | ||||||||||
| O | — | ||||||||||
| P | — | ||||||||||
| Q | — | ||||||||||
| R | — | ||||||||||
| S | — | ||||||||||
| T | — | ||||||||||